pH Meter Pro 4-in-1 (Zamnesia)
The Zamnesia pH Meter Pro 4-in-1 checks pH, EC, TDS and temperature in one device, so you don't need separate testers for your nutrient tank. It's factory-calibrated, comes with buffer powders for recalibration, and has a replaceable electrode. Suits hydro, coco and soil growers feeding to a schedule.
| Buy 3 units | 5% Discount |
| Buy 5 units | 10% Discount |
| Buy 10 units | 15% Discount |
One reading for pH, nutrient strength and temperature
The Zamnesia pH Meter Pro 4-in-1 checks pH, EC, TDS and water temperature in one go. pH tells you whether your plants can actually absorb what's in the tank. EC (electrical conductivity) tells you how strong that feed is, and TDS gives you the same strength reading as a ppm or ppt figure. Press MODE to cycle between pH, EC and TDS, and the temperature shows alongside whichever reading you're on. Instead of checking three things with two different pens, you get the full picture on one display.
Set up once, then just top up calibration
The meter comes factory-calibrated, so it's ready to use straight out of the box. When it's time to recalibrate, you get pH buffer powders for 6.86, 4.00 and 9.18 included, and the meter supports up to 3-point pH calibration plus EC calibration at 1413 µS/cm and 12.88 mS/cm. The box holds the meter, the three buffer powders, and a manual, nothing else to track down before your first check.
Built to last past one worn probe
The electrode is the part that wears first on any pen meter, and here it unscrews and swaps out, so a tired probe doesn't mean binning the whole unit. HOLD freezes a reading so you can pull the probe out of the tank and read it properly, and a long press toggles between °C and °F. It's backed by a 3-year warranty on materials and workmanship.
If pH is all you need to track, the Basic pH Meter covers that on its own. Step up to the Pro once you're dosing nutrients to a schedule and want EC, TDS and temperature in the same check.
